5 Ton 10 Ton Single Beam Overhead Crane Max Lifting Height 30m Electric Motors Driving

5 ton 10 ton EOT Single Girder Bridge Crane Max Lifting Height 30m

5t to 20t Single Girder Overhead Crane (LDA)

Specifications:
1) Load: 5-20t
2) Span: 10.5-35.5m
3) Lifting height: According to your requirements.
4) Working duty: A3.

LDA Model Single Girder Overhead Cranes are widely used in various places such as factory, warehouse, and stuff yards to lift goods, forbidden to be used in flammable, explosive and corrosive environment. The work class is A3. Hoisting Capacity: 5-20T, span: 10.5-31.5m. These kinds of products are operated by ways of ground and cabin control. There are open and closed styles for driver's cabin; It could be divided into left and right installation according to practical situations. Entrance direction adopts profile and top entering to satisfy different needs of customer's choice. The crane can be used for both indoor and outdoor operations and water-proof cloth is needed in out door operation.

1. Main beam- The main traveling structure of the crane which spans the width of the bay and travels in a direction parallel to the runway. The bridge consists of two end trucks and one or two bridge girders depending on the equipment type. The bridge also supports the trolley and hoisting mechanism for up and down lifting of load.
2. End trucks- Located on either side of the bridge, the end trucks house the wheels on which the entire crane travels. It is an assembly consisting of structural members, wheels, bearings, axles, etc., which supports the bridge girder(s) or the trolley cross member(s).
3. Bridge Girder(s)- The principal horizontal beam of the crane bridge which supports the trolley and is supported by the end trucks.
4. Runway - The rails, beams, brackets and framework on which the crane operates.
5. Runway Rail- The rail supported by the runway beams on which the crane travels.
6. Hoist- The hoist mechanism is a unit consisting of a motor drive, coupling, brakes, gearing, drum, ropes, and load block designed to raise, hold and lower the maximum rated load. Hoist mechanism is mounted to the trolley.
7. Trolley -The unit carrying the hoisting mechanism which travels on the bridge rails in a direction at right angles to the crane runway. Trolley frame is the basic structure of the trolley on which are mounted the hoisting and traversing mechanisms.
8. Bumper (Buffer)- An energy absorbing device for reducing impact when a moving crane or trolley reaches the end of its permitted travel, or when two moving cranes or trolleys come into contact. This device may be attached to the bridge, trolley or runway stop.

Single Girder Overhead Crane Drawing